Communication channels

Sending notices in «Solovej» security system is carried out via the following communication channels

• two telephone numbers for the transmission in digital format (ADEMCO Contact ID or ADEMCO Express);
• one phone number for notification in text form (SMS);
• radio LARS.

Transmission protocols

The device supports the following notice protocols:

• advanced ADEMCO ID Contact;
• ADEMCO Express;
• radio LARS.

Control

To control this device can be used:

• remote keyboard;
• key fobs;

This device provides up to four key fobs with individual codes and their separate identification. Each key fob has two buttons: «Security» («1») used for arming and disarming, «Panic» («2») – to send an emergency message (if you need one of these features can be turned off).

Protection zones

Device «Solovej» supports up to six protection zones.

You can connect to up to six alarm loops. Loops power supply - 12V. The device captures three loop states: a closed, normal and open in «normal», «fast», «special» modes. In «protected» mode the device fixed 5 states: normal, triggering of one sensor, triggering two or more sensors, circuit loop and break loop.

You can connect the loop powered sensors with a supply voltage of 12V and total input current to 0.6 mA in normal mode or to 1.5 mA in «special» mode. You can also use sensors with external power supply, and the sensors can be powered from the device if not exceeding the maximum current (0.8 A for all external devices).

The mode of each zone is set individually in the device programming.

Alarm loops parameters are shown in the table below:

Exit and entry delay

The delay time to the exit and entry can be set in the range 0...180 sec.

 Power

The device is powered by AC 220V (+ 22-33), frequency 501 Hz. The power consumed by the device from the mains, do not exceed 40 watts. There is also a built-in power backup power supply (optional) - battery FIAM-GS 7.2 Ah. Switching to backup power source and back, and the battery charge when the primary power supply is carried out automatically. A fully charged battery provides the device for at least 24 hours (without additional devices).

Keyboard

The device uses remote keyboard ADEMCO 6145.

Control of external devices

Device «Solovej» has relay designed for connection of additional external devices (such as light or sound the alarm). Maximum current switching relay - 2 A, maximum voltage - 400 V. Relay can be switched on or off according to the user defined events at a specified time or the commands from the keyboard.

The external devices power

You can connect a power supply external devices (light or acoustic alarms, detectors, etc.) with a supply voltage of 12V. You may connect devices with a total current up to 0.8 A.

Logging

Device «Solovej» provides management and viewing event log. Log capacity is 32 events.

Messaging

Alarm messages from the device are transmitted to the monitoring desk and / or the user's mobile phone as an SMS message.

The device can periodically send its status test messages to the monitoring desk. Periodicity of sending test messages is programmed within the 2 ... 18 hours. Test messages may be sent on any of the possible communications channels (including all simultaneously).

Provides the possibility of rapid diagnosis, including the loops monitoring, battery monitoring, checks of radio and GSM-modem, check connection with monitoring desk.

Dimensions of security device «Solovej» (excluding antennas) no more 230x 110x 230 mm., Weight not more than 6 kg.

Operating temperature range from – 10°C to + 40° C, with relative humidity to 90% at 25° C.

Scope of delivery

Scope of delivery «Solovej» is shown in the table.

On customer request, the device is equipped with a large number of key fobs, battery, light siren «Mayak».